Your cart
There are no more items in your cart
AC-DC MULTI-STAGE DIMMABLE with DALI LED DRIVER - CONSTANT CURRENT - 60 W - SELECTABLE OUTPUT CURRENT WITH PFC
LCM-60DA
Out-of-Stock
€88.96
Tax included
AC-DC MULTI-STAGE DIMMABLE with DALI LED DRIVER - CONSTANT CURRENT - 60 W - SELECTABLE OUTPUT CURRENT WITH PFC
Specification(s):
- constant current mode output with mutiple levels selectable by dip switch
- plastic housing with class II design
- built-in active PFC function
- standby power consumption < 0.5 W
- functions:
- DALI interface (logarithm or linear dimming curve selectable)
- push dimming
- synchronization up to 10 units
- current level: selectable via DIP switch, plese refer to "DIP SWITCH TABLE" section
- 3 years warranty
- output:
- selectable current: 500 mA / 600 mA / 700 mA / 900 mA / 1050 mA / 1400 mA
- DC voltage range: 2-90 V / 2-90 V / 2- 86 V / 2-67 V / 2-57 V / 2-42 V
- rated power: 60.3 W
- open circuit voltage (max.): 95 V
- current ripple: 5.0 % max. @rated current
- current tolerance: ± 5.0 %
- auxiliary DC output: nominal 12 V (deviation 11.4 - 12.6 V) @50 mA for AUX-Type only
- setup time: 500 ms / 230 VAC
- input:
- voltage range: 180-295 VAC 254-417 VDC
- frequency range: 47-63 Hz
- power factor (typ.): >= 0.975 / 230 VAC; >= 0.96 / 277 VAC at full load
- total harmonic distortion: lower than 20 % when output load is 75 % or higher
- efficiency (typ.): 92 %
- AC current (typ.): 0.32 A / 230 VAC; 0.27 A / 277 VAC
- inrush current (typ.): cold start 20 A (twidth = 270 µs measured at 50 % Ipeak) at 230 VAC
- max. number of PSUs on 16 A circuit breaker: 25 units (circuit breaker of type B) / 32 units (circuit breaker of type C) at 230 VAC
- leakage current: < 0.5 mA / 240 VAC
- standby power consumption: < 0.5 W for Blank-Type, < 1.2 W for AUX-Type
- protection:
- short circuit: constant current limiting, recovers automatically after fault condition is removed
- overvoltage:
- 105-125 V
- protection type: shut down output voltage, re-power on to recover
- over-temperature: shut down output voltage, re-power on to recover
- functionality:
- temperature compensation: by external NTC thermistor
- dimming
- synchronization
- environment:
- operating temperature: -30 to +90 °C
- max. case temp. : +90 °C
- operating humidity: 20-90 % RH non-condensing
- storage temperature humidity: -40 to +80 °C, 10 -95 % RH
- temperature coefficient: ± 0.03 %/°C (0-50 °C)
- vibration: 10-500 Hz, 2G 10 min/1cycle, period for 60 min each along X, Y, Z axes
- safety & EMC:
- safety standards: UL8750, CSA C22.2 No. 250.13-12, ENEC EN61347-1, EN61347-2-13, EN62384 independent approved, GB19510.14, GB19510.1, BIS IS15885, EAC TP TC 004 approved
- DALI standards: comply with IEC62386-101, 102, 207
- withstand voltage: input to output: 3.75 kVAC
- isolation resistance: input to output: > 100 Mohm / 500 VDC / 25 °C / 70 % RH
- EMC emission: compliance to EN55015, EN61000-3-2 Class C (>= 40 % rated power); EN61000-3-3, GB17625.1, GB17625.1, GB17743, EAC TP TC 020
- EMC immunity: compliance to EN61000-4-2,3,4,5,6,8,11, EN61547 light industry level (surge 2 kV), EAC TP TC 020
- others:
- MTBF: 193.6 K hrs min. MIL-HDBK-217F (25°C)
- dimensions (L x W x H): 123.5 x 81.5 x 23 mm
- packing: 0.24 kg; 54 pcs / 15 kg / 1.12 ft³
- EAN: 5410329716929